- #Signcut pro 2 with auto contour how to
- #Signcut pro 2 with auto contour manuals
- #Signcut pro 2 with auto contour Pc
- #Signcut pro 2 with auto contour download
It doesn't matter how many layers you use, but it's good to keep your contour layer on top so you can hide and isolate it for sending over to SignCut.ġ. Note that the contour layer exists on its own layer.
#Signcut pro 2 with auto contour download
Illustrator users, download this sample here. Download and use them to learn the contour-cutting process, or you can make your own in the next section in the tutorial. It's a good idea to write those values down somewhere in case you need them again. You will only need to do this once, and the values are stored in SignCut.
You now have set the offset the knife holder has in relation to the laser point.
#Signcut pro 2 with auto contour Pc
Use the arrow keys on your PC numeric keyboard, screen or a USB handheld numeric keypad and move the laserpointer to the center of the crosshair. A crosshair will be printed on the paper.
Under Settings/Settings click 'Calibrate Laserpoint Offset'. Put the cutter online if it isn't already. Load the plotter pen into your cutter, and in SignCut, set your offset to 0mm, with 3-point calibration enabled. If the cutter says 'waiting' then you will need to cycle the power so you can set your new origin. Put a regular sheet of paper in your cutter, and set home origin in the middle of it. Start with a properly working cutter! For basic setup check the Noobie guide written by Paco. See, he did all the hard work, I am but a scribe who re-wrote the tutorial in a way I understood it better and with a few more tips.
#Signcut pro 2 with auto contour manuals
These are the original manuals here if you want to see them (written by Paco). After learning from him, I did like 50 zillion contour cuts, made a lot of mistakes and learned a lot.
#Signcut pro 2 with auto contour how to
I have to give him all the credit for teaching me how to do it. I am just adding it to this site in my own words to clarify a few things which confused me and to add a few tricks of my own.
0 kommentar(er)
